Planning Your Cladding Project
Flexible stone veneer turns ordinary walls into stone feature surfaces with minimal buildup. This guide covers the essentials from substrate to care.
Substrates
Suitable bases include plasterboard, plaster, concrete, plywood, MDF and existing tile (clean and sound). The substrate must be dry and stable; flexible veneer follows the shape beneath it.
Surface Preparation
Fill imperfections, sand glossy surfaces, and prime dusty or porous walls. A clean key is the most important factor in a long-lasting bond.
Choosing Adhesive
Use a polymer modified thin-set or a high-tack tile adhesive suitable for the substrate. For curved or low-porosity surfaces, a flexible grab adhesive improves hold.
Application
Trowel adhesive at 4 to 6 mm, press the sheet, and roll to remove air. Keep a tight, staggered seam. Cut with a standard utility knife or score-and-snap. Work top down or bottom up depending on access.
Corners and Edges
Outside corners can be wrapped or finished with a trim. Inside corners are best filled with a flexible grout.
Feature Walls
A single stone feature wall behind a sofa or bed creates impact without the cost of full-room cladding. Pair with the curved surface guide for columns and arches.
Care
Seal porous varieties and clean with pH-neutral products. See maintenance for detail.
Frequently Asked Questions
Can I clad over existing tiles?
Yes, if the tile is sound and clean. A bonding primer helps.
Do I need to seal?
For most interiors a sealer improves stain resistance; high-traffic areas should be sealed.
Best products for walls?
Travertine DS001, BY30060 and the full range. Request samples.
